Tina Turner Premuim Guitar Picks at Amazon
|
TIP 1 – First check your cable. Most times all you have to do is tighten both ends, and this will eliminate that scratchy sound you get after plugging your bass onto your amp. This is just one way to find out where the undesirable noise is coming from. Another way to find the scratchy sound you listen is to focus on your cable, rather then your bass guitar. Simply use a dissimilar bass and the same cable, and if you still get a scratchy sound still, then that scratchy sound is coming from your cable and not your bass. Bad cables may cause a lot of this same kind of sound, you may have short, so go visit the music store and pick up a cable with gold tips. TIP 2 – If you have tried using a new cable for your bass and the sound still occurs, then you may want to have a look in side your bass. Sometimes at the sitting of the jack input of your bass, could be lose and just need a little tightening. It is very commend that this area loosens after plugging your cable in and out after a amount of time of time. Also you need to look around the wiring of your bass also; from time to time you could have a short near the jack area. If you have done troubleshooting tip 1 and 2, and you still have a scratchy sound, then you may want visit an electronic store and find numerous electrical contact cleaner for your pots. Sometimes your pots in your guitar give that a good deal of scratchy sound also. If you feel uneasy with regards to troubleshooting your own bass, then you best bet is to take it in to guitar repairman. If all else fails, dude you may want to have you amp checked out! |
